V. Control Method and LED Indicator
1. Button ④ is used to switch band and channel; every time when button ④
is pressed for a short time to switch to the next channel, the red LED ①will
flash, 1.2.3.4.5.6.7.8 in turn. The operation can be cyclic; see the following
diagram for details!
Short press button ④ to switch channel
Red
LED
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
Flash once Flash twice Flash for 3 times Flash for 4 times Flash for 5 times Flash for 6 times Flash for 7 times Flash for 8 times
2. Long press button ④ to switch frequency bands. Long press for 5
seconds and the corresponding blue LED will flash, indicating frequency
groups A and B in sequence. This operation can be repeated; see the figure
below for details!
Press and hold button ④ to switch channels
Blue LED
Band A
Band B
Flash once
Flash twice
3. Button ⑤ is the power adjustment button. Each short press switches the
power by one level, cycling between 25mW, 2000mW, and 4000mW. The
green LED is the power indicator light, with the following statuses as shown
in the figure below: 25mW flashes once, 2000mW flashes twice, and
4000mW flashes three times. Holding the button for 3 seconds enters pit
mode, with the green light staying on. See the figure below for details!
Short press button ⑤ Power switch
Green LED
Pit Mode
25mw
2000mw
4000mw
Everlasting brightness
Flashes 1 time
Flashes twice
Flashes three times
Note: This image transmission device has a temperature protection function.
When the temperature of the image transmission device exceeds 100°C,
the transmission power of the image transmission device will be reduced by
one level. If the temperature remains above 100°C, the transmission power
will be reduced by another level until it reaches the lowest power level
(25mW). At this point, the temperature of the image transmission device
will decrease. When the temperature drops to 95°C, the transmission
power will return to the originally set power level.
Your message must be between 20-3,000 characters!
